Any enquiries regarding this Notice should be addressed to : The Senior Petroleum Measurement Inspector Tel. 01224 254060
1. Model Clauses of the Schedules in the Petroleum Act 1987 and in the Petroleum (Production) Regulations from 1988 require that the Licensee shall measure by methods customarily used in good oil field practice and from time to time approved by the Minister all petroleum won and saved from the licensed area. It is, therefore, necessary for the Licensee to submit his metering proposals to Petroleum Measurement Inspectors for approval, and it is advisable to do this at the early design stage of the metering station. Petroleum Measurement Inspectors should be contacted for all metering proposals for oil and gas at the address below.
2. The following information will be required:
1. A complete specification of the metering station with dimensioned drawings and relevant descriptive literature. Sufficient information should be included to enable a check on the design of the metering station to be made.
2. A description of the proposed operating procedure including routine calibrations and checking of equipment for maintenance of accuracy.
3. Specimen calculations indicating how reported quantities of oil or gas production are obtained giving correction factors proposed for converting meter and instrument readings to standard conditions.
3. It should be noted that:
1. Petroleum Measurement Inspectors require to be advised in sufficient time to witness factory tests such as prover loop calibration, systems check, flow tests, etc.
2. Before start up and commissioning of a metering station an inspection by a Petroleum Measurement Inspector may be carried out. The operator will be expected to provide the Inspector with all relevant data and information, and to carry out such tests as the Inspector may require. Reasonable notice should be given to the Petroleum Measurement Inspector as to when an operator will be ready for a pre -start up inspection.
3. No alterations to a metering system may be carried out without the previous consent of a Petroleum Measurement Inspector.
4. The method of reporting petroleum production and the details required is the subject of a separate Notice PON No.7.
Department of Trade and Industry
Oil and Gas Office
Atholl House
86 -88 Guild Street
ABERDEEN AB9 1DR
Tel. (01224) 254064
Fax. (01224) 254089
Back
| Title
| Table of Contents
Appendix 1 | Appendix 2 | Appendix 3 | Appendix 4 | Appendix
5 | Appendix 6 | Appendix 7 | Appendix 8 | Appendix 9
Appendix 10 | Appendix 11 | Appendix 12 |
Appendix 13 | Appendix 14 | Appendix 15 |
Appendix 16 | Appendix
17
Index Map | Plate 1 |
Plate 2W | Plate 2E | Plate 3W | Plate 3E | Plate
4W | Plate 4E |
Plate 5 | Plate 6
Plate 7 | Plate
8W | Plate 8E | Plate 9W | Plate 9E | Plate 10W | Plate
10E | Plate 11 | Plate 12 | Legend